Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATIONS
•
Do not use the extractor for a task it was not designed to perform.
Do not operate the extractor if any parts are damaged or missing as this may cause failure or
•
possible personal injury.
•
Do not get the extractor wet or use in damp or wet locations or areas where there is
condensation.
Do not allow untrained persons to operate the extractor.
•
•
Do not operate the extractor when you are tired or under the influence of alcohol, drugs or
intoxicating medication.
Do not use the extractor where there are flammable liquids, solids or gases such as paint
•
solvents, etc.
•
Do not leave the extractor operating unattended..
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information. Dispose of this product at the end of its working life environmentally.
COMPONENTS
1
Roll frame
2
Hose housing
3
Fixing screws
4
Height adjustment
5
Hose, flexible
6
Exhaust filter
7
Compressed air shut-off valve
8
Compressed air connection
9
Exhaust gas funnel / exhaust gas inlet
10 Pipe clamp wing nut
COMPRESSED AIR SUPPLY
The compressed air connection (8) and all other components are shown in chapter "COMPONENTS".
Make sure that the compressed air shut-off valve (7) is in the "closed" position before connecting the
device to the compressed air.
A compressed air supply with a pressure of 6.2 bar (90 PSI) and an air flow of 454 l/min (16 CFM) is
required for this device.
Make sure that the compressed air is clean and does not exceed the specified maximum pressure.
Excessive pressure or unclean air shortens the life of the extraction system and can cause property
damage and personal injury.
Drain the compressor's compressed air tank daily. Water in the compressed air line can cause
damage.
Clean the compressor intake air filter weekly.
Line pressure should be increased to compensate for unusually long air hoses (over 8 meters). The
inner diameter of the hose and the fittings should be at least 6.3 mm (1/4 ").
Keep hoses away from heat, oil and sharp edges. Check the hoses for wear and make sure that all
connections are tight.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
