Preparations Before Use; Inserting The Batteries; Handling Tips; Getting Accurate Readings - Tanita BC-1500 plus Manual De Instrucciones

Preparations before use

Open as shown.
Direction of
the batteries.

Handling Tips

This monitor is a precision instrument utilizing state-of-the-art technology.
To keep the unit in the best condition, follow these instructions carefully:
• Do not attempt to disassemble the measuring platform.
• Store the unit horizontally.
• Avoid excessive impact or vibration to the unit.
• Place the unit in an area free from direct sunlight, heating equipment, high humidity, or extreme temperature change.
• Never submerge in water. Use alcohol to clean the electrodes and glass cleaner (applied to a cloth first) to keep them shiny; avoid
soaps.
• Do not step on the platform when wet.
• Do not drop any objects onto the platform.
• Do not use this monitor while operating transmitters (such as a cell phone) as this may affect your results.
• If not in use for prolonged period of time it is recommended that you remove the batteries.

Getting accurate readings

Heels centered on
electrodes
Note: An accurate reading will not be possible if the soles of your feet are not clean, or if your knees are bent or you are in a sitting
position.

Inserting the Batteries

Open the battery cover on the back of the measuring platform. Insert the supplied
AA-batteries as indicated.
Note: Be sure that the polarity of the batteries is set properly. If the batteries are
incorrectly positioned the fluid may leak and damage floors. If you do not intend to
use this unit for a long period of time, it is advisable to remove the batteries before
storage.
Please note that the included batteries from the factory may have decreased energy levels
over time.
Positioning the Monitor
Place the measuring platform on a hard, flat surface where there is minimal vibration to
ensure safe and accurate measurement.
Note: To avoid possible injury, do not step on the edge of the platform.
Toes may overhang
measuring platform
To ensure accuracy, readings should be taken without clothing and
under consistent conditions of hydration. If you do not undress,
always remove your socks or stockings, and be sure the soles of
your feet are clean before stepping on the measuring platform.
Be sure that your heels are correctly aligned on the measuring
platform. Don't worry if your feet appear too large for the unit-
accurate readings can still be obtained if your toes overhang the
platform.
It is best to take readings at the same time of day. Try to wait about
three hours after rising, eating, or hard exercise before taking
measurements.
When Heart Rate (HR) measurement is available, the monitor starts
to measure HR after Body Composition measurement.
HR value should be higher after exercise or taking a bath.
While readings taken under other conditions may not have the same
absolute values, they are accurate for determining the percentage of
change as long as the readings are taken in a consistent manner. To
monitor progress, compare weight and body fat percentage taken
under the same conditions over a period of time.
EN
4