Wiesenfield WIE-BK-60 Manual De Instrucciones página 15

Manually rotate the inner basket to check that it is working properly.
Place the unit on a hard floor and mark the areas of the circular holes in the lower parts of the feet. Once this has been done,
move the unit away.
Drill the holes (minimum diameter 10 mm, minimum depth 65 mm), drive the wall plugs into the floor (choose the type of
plugs according to the type of floor) and place the unit according to the position of the screws, then tighten the screws.
3.4. Device use
Set the ON/OFF switch to the "0"/"STOP" position; turn the speed control knob counterclockwise to the "0" position.
Plug the power cord into an AC power outlet.
Insert the frames (honeycombs) into the inner basket of the machine. Load two or four on opposite sides to keep the unit
balanced during operation.
Close the lid to connect the safety switch (automatically cuts off the power when opened), close the emergency switch, set
the ON/OFF power switch to the "I" position, turn the speed control knob clockwise until the internal basket reaches the
required speed.
When finished, turn the ON/OFF power switch back to the "0"/"STOP" position and turn the speed control knob to the "0"
position. When the internal basket stops rotating, open the lid and check that honey extraction is proceeding correctly.
Repeat the honey extraction process if there are honey residues in the comb cells.
If there is no honey residue in the comb cells after extraction, perform the following steps:
Invert the frames and put them back into the inner basket of the honey extractor. Repeat the extraction process until the
honey is completely extracted.
Place the bucket/container under the honey valve and open it and the honey will drain into the bucket/container. Tilt the
unit forward so that as much honey as possible flows out.
The lid has a built-in safety switch that cuts off the power when it is opened.
Warning: Do not open the front cover while the device is operating to reduce the possibility of injury.