Insta360 Go 3 Dive Case Manual Del Usuario página 11

Maintenance
①
Do not open the Dive Case while it is wet.
②
After using the product in seawater, remove the camera and soak the Dive Case
in freshwater for at least 60 minutes. If the Dive Case is not soaked after use in
seawater, residual salt may cause water leakage. After soaking the Dive Case in
freshwater, rinse it gently under the tap. Never apply a high-pressure water flow
from a single direction, as it may cause leakage.
③
Ensure that the Dive Case is firmly closed before washing. After washing the
Dive Case, wipe away any water droplets remaining on the surface with a soft,
dry cloth. Do not dry it with a hair dryer, clothes dryer or stove.
④
Ensure there is no sand on the Dive Case before drying. Sand may scratch the
product surface when wiped with a cloth.
⑤
Do not store the Dive Case in a hot and humid environment. In particular, do not
leave it inside a hot car.
⑥
Do not wash the Dive Case with soap, neutral detergent or alcohol cleaning
products. This may degrade the waterproofing performance.
⑦
Do not clean the Dive Case with organic solvents (such as diluents, alcohol or
gasoline).
⑧ Store the product in a dry, well-ventilated location.
7