Publicidad
3.2.
Assembling the device
Remove all parts from the packaging.
•
•
Fill the solar fountain with clean tap water.
•
Place the pump under the water and make sure it is fully submerged in the water.
•
Connect the pump cable to the control box socket on the back of the solar panel; the light cable connector and the
pump back light cable connector should be well connected before putting it in the water (if the fountain has lights).
•
Ensure that the solar panel is exposed to direct sunlight.
•
The solar fountain is now ready for use.
3.2.1.
HT-SF-101:
Place the lower reservoir on top of the base and turn the lower reservoir clockwise to secure it..
Feed the pump supply line through the plastic tube at the bottom of the base, the line will come out of the channel at the
bottom of the base.
1 – Lower reservoir
2 – The base
1 - Pump supply line
2 - Pump
3 - Plastic tube
4 - Base
Publicidad
