Lampa FC-20 Instrucciones De Uso página 19

• Power Supply: connect the appliance to either DC 12/24V or AC 220-240V power supply (use the
included dedicated AC 220-240V adapter).
• Display Screen Initialization: connect the appliance to a power supply, the cooling box will emit a
long beeping sound and the display will be on for 2 seconds before entering in normal operating mode.
• Power ON/OFF: Press
Temperature Setting: press + or – to set the required temperature. It will take 3 seconds for the
•
appliance to save the required temperature (Note: the temperature displayed is the current required
temperature, after setting it the appliance will need some time to reach the set temperature).
Temperature setting range: -20°C~20°C/-4°F~68°F.
Cooling mode: when the appliance is ON and running, press
•
to switch to ECO mode (energy saving mode). (Factory setting is MAX).
• Battery Protection Mode: when the appliance is ON and running, press
the screen flashes, then press it again to select the required protection mode: H (High), M (Medium), L
(Low). (Factory setting is H).
• Voltage Reference:
The voltage is only a theoretical value, as it may vary depending on different conditions and scenarios.
H should be set when the appliance is connected to the car's power supply, while M and S when the product
is connected to a portable or a back-up battery.
• Temperature's Unit of measure: Turn OFF the appliance as instructed above, then press
seconds until E1 shows up on the display, then switch to E5 by pressing multiple times on
E5 mode press + or – to select Celsius of Fahrenheit. (*Factory setting is °C.).
• Reset: Turn OFF the appliance as instructed above, then press
display. When in E1 mode, press + – simultaneously for 3 seconds to reset the appliance.
• Recommended temperature for common food:
to switch the appliance ON or OFF.
to switch to MAX mode, press it again
for a few seconds until
for 3 seconds until E1 shows up on the
EN
for a few
. When in
19