Remote Controller; Installation Of Batteries - Impecca DVHP-9109 Manual De Usuario

REMOTE CONTROLLER

POWER
NUMBER KEYS
MENU / PBC
UP
LEFT
DOWN
TITLE
DVD/USB
DVD/USB
VOL - : Press to DECREASE the volume.
PREV - Press to return to the previous title /chapter / track.
NEXT - Press to skip to the next title /chapter / track.
STOP - Press to stop a DVD or CD during play.
PLAY/PAUSE - Press to play or pause a loaded disc .
DVD/USB - To change the video output mode.
OSD - Press to view the various On Screen Display modes.
WIDE - Press to switch between different aspect ratio settings.
ZOOM - Press to zoom in or out of a picture on the screen.
L/R - Press to adjust the audio mode of a supported DVD.
N/P - Press to change the output signal to NTSC / PAL / AUTO.
SLOW - Press to view the loaded DVD in slow motion.
REPEAT - Press to enable repeat play of track or tracks.
REV - Press to scan backward. Press again to increase scan speed ( 2x, 4x, 8x, 16x, 32x).
FWD - Press to scan forward. Press again to increase scan speed ( 2x, 4x, 8x, 16x, 32x).
STEP - Press to advance one frame at a time.
A-B - Press to create a repeating loop of a specified section of a loaded DVD.
POWER - Press to turn the power On/Off or
restore the DVD player to standby mode.
OPEN/CLOSE - Press to open and close the disc
drawer.
MUTE - Press to mute or unmute the volume.
LANGUAGE - Change audio language tracks.
NUMBER KEYS - Input numbers when in
Program mode.
GOTO - Go to a specific play time/point on a DVD.
ANGLE - Press to access different camera
angles on supported DVDs.
PROGRAM- Press to program a DVD to play
chapters or tracks in a specified order.
MENU - Open the main menu.
SETUP - Press to access the setup menu.
UP/RIGHT/LEFT/DOWN - Press directional
buttons to navigate through menu screens.
ENTER - Press to confirm selections within on-
screen menus or the setup menu.
TITLE - Press to access the title menu of a
loaded DVD.
SUBTITLE - Press to turn available subtitles on
or off.
VOL + : Press to INCREASE the volume.

INSTALLATION OF BATTERIES

1. Press and lift the back cover up to open
the battery compartment of the remote
control.
2. Insert two AAA size batteries. Make sure
that the polarities of the batteries ( + )
and ( - ) match those of the battery
compartment.
3. Close the battery compartment cover.
6