Jata electro BT1034 Instrucciones De Uso página 9

• Do not use the blender on empty.
• Don't allow children play with the appliance. Keep the appliance
out of the reach of children.
• Do not remove the jug with the food until the blade is totally
stopped and the appliance has been switched off.
• Make sure neither the appliance nor the cables are in direct
contact with hot surfaces or objects.
• Always place it on a flat surface.
• Always disconnect it from the mains when you do not use it and
before assembling / disassembling or when cleaning.
• Take all necessary precautions while handling the blade, as it is
very sharp.
• The cleaning and maintenance done by user can not be done by
children without any supervision.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
INSTRUCTION OF USE
• Fit the jug (3) on the main body (4).
• Pour the food into the jug and place the lid on it. Make sure the blender is perfectly closed and maintain always
held while in use.
ATTENTION:
- Do not pour food or liquids too hot.
• To avoid overfilling do not pour more than 1L of liquid at the time.
• Plug the appliance into the mains. The ring will light up (6). This ring will stay always on when the blender is
connected to the mains and the jug inserted.
• Turn the speed selector (5) clockwise between Min. and Max. position till getting the desired speed.
• You may add ingredients to the jug while in use without open the lid. To do so, remove the stopper (1). Turn
it slowly anti-clockwise and take it out. Add the ingredients into the jug and place again the stopper making
coincide the two flanges into the guides of the lid and turn it slightly clockwise.
• Once you have finished, set the speed selector to its " 0" position and wait for the blade to stop turning completely
before removing the jug.
KNOBS USING
• To use any of the 3 knobs, the speed selector must be placed at the " " position.
SMOOTHIE KNOB
• Push this knob and the blender will work at the maximum power.
AUTO / PULSE KNOB
• Pushing this knob the blender will work intermittently for 3 cycles and then it will work continuously for about 1
minute. At the end of this period of time the blender will stop working automatically.
ICE CRUSH KNOB
• Pushing that knob the blender will works intermittently. For it, we suggest to use little ice cubes, or you can
bit them before putting them on the blender, to avoid the "igloo" effect. This means that the crushed ice gets
adhered to the blender walls, and it impedes that the other ice cubes arrive to the base to be crushed.
MAINTENANCE AND CLEANING
• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• The blade set can be totally removed for cleaning. This operation can be done in two ways:
9