AENO RC2S Guia De Inicio Rapido página 11

Control of the vacuum cleaner using the buttons on its body
To start cleaning, turn on the "START/STOP" button on the body of the vacuum
cleaner (see figure e). Press the "START/STOP" button again to stop the
device. Upon pressing the "BASE" button
docking station to recharge.
WARNING! The robot vacuum cleaner automatically stops cleaning and
returns to the docking station to recharge if its battery level is too low.
Remote control of the vacuum cleaner
You can control the vacuum cleaner via the AENO mobile app.
ATTENTION! Make sure your smartphone is connected to a 2.4 GHz Wi-Fi network.
• Connect the docking station to the power supply.
• Log in to your AENO app account or create a new one; to do that, download
the mobile app from Google Play or the App Store.
• Tap "+" or "Add device" on the home screen of the app. In the window that
opens, select the "Vacuum Cleaner" category.
Note: If the system prompts you to turn on some features on your smartphone,
follow the recommendations in the prompts.
• Enter your Wi-Fi network name and password if the fields had not been filled
automatically. Make sure that the AP mode is selected in the upper right corner.
• Press the Start/Stop button to turn on the vacuum cleaner. After 15 seconds,
on the control panel, press and hold the Wi-Fi button until the button light
starts flashing. Then check the "Make sure the LED indicator is blinking" box
on the Connection Instructions screen and tap "Next".
• Connect your smartphone to the Wi-Fi hotspot named "Smart Life – XXXX".
Go back to the app and tap "Connect".
• Wait for the "Device successfully added" message to appear.
Note: The device can also be operated via voice assistants. Detailed information
is available in the complete operation manual at aeno.com/documents. If the
connection fails, make sure the device is plugged into a power source, turned
11
the vacuum cleaner returns to the
aeno.com/documents