Publicidad
Power Button
(For Power Adapter)
Installation
Power on the access point
To power on the DWL-3610AP, you can use ONE of
the following methods:
1. Connect the supplied power adapter
OR
2. Plug one end of an Ethernet cable into the LAN
port of the DWL-3610AP and the other end into
a port on a PoE switch.
Configure the access point
To set up and manage the DWL-3610AP, use one
of the following methods:
•
Manage the access point from the computer:
Connect the access point and your computer
directly via a straight-through Ethernet cable.
DWL-3610AP
•
Manage the access point from the computer
via the Switch or Router: Connect the
access point and your computer to the same
switch or router.
Switch or Router
DWL-3610AP
DWL-3610AP
Reset Button
Computer
Computer
Computer
•
Manage the access point from the computer
via the Unified Wireless Switch or Wireless
Controller: Connect the access point to
a Unified Wireless Switch or Wireless
Controller. Connect your computer to the
same network as that of the Unified Wireless
Switch or Wireless Controller.
Unified Wireless Switch
DWL-3610AP
DWL-3610AP
Wireless Controller
Mounting Options
You can mount a DWL-3610AP access point on any
of the following types of surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
Use a CAT 5 cable with an even sheath.
The Ethernet ports on the DWL-3610AP access
point cannot accept a CAT 5 cable that has an
uneven sheath; the RJ-45 connector on the cable
will not fit properly into the receptacle on the access
point.
Wall Installation Recommendations
If you plan to install the DWL-3610AP on a wall or
other vertical surfaces, orient the top of the access
point (the side with the LEDs) toward the intended
coverage area. The radio antennas transmit through
the top of the access point but not through the
bottom (where the bracket is).
Warning: The DWL-3610AP is designed to
receive PoE power only from an 802.3af-compliant
source, or from a D-Link-approved power injector.
Connecting an access point to a Power over
Ethernet (PoE) device that is not approved by
D-Link can damage the equipment.
Warning: This product is to be connected only to
PoE networks without routing to the outside plant.
The equipment power cord must be connected to
a socket-outlet earthling connection.
D-Link DWL-3610AP Quick Install Guide 3
D-Link DWL-3610AP Quick Install Guide 3
Computer
Computer
or
Publicidad
