Publicidad
Idiomas disponibles
Idiomas disponibles
Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product
must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and
may be used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
rotary knob adjusts the time between discharges when the timer function is
engaged.
rotary knob controls the volume of the fog produced.
rotary knob adjust each duration of fog emission.
The yellow
button controls the timer function. Press the button to activate, when
activated the yellow LED turns on.
The red
button sets the machine to constant fog production. Press the button
to activate, when activated the red LED turns on.
The green
button will produce a continuous blast at maximum volume while the button is held down.
We recommend a frequent cleaning of the unit, in particular the output nozzle.
There are no serviceable parts inside the unit except for the fuse. Repairs and service operations are only to be carried out by
authorized dealers.
Disconnect from mains before starting maintenance operation!
•
Ensure the fluid do not become contaminated.
•
Ensure the air vents are not clogged by dust. If necessary remove the dust.
•
Ensure that the unit can not get overheated.
Do not run the unit without any fluid, as the pump will run dry.
•
Wipe up spilled Fluid immediately. Moisture and fluid can permanently damage the electrical components of the unit.
•
•
If you install the unit make 100% sure that a permanent fog-free air supply for the unit is guaranteed. Cooling air with too high fog
concentration (very often in Clubs and Discos) can condense inside the unit and cause moisture damage.
•
For cleaning the surface of the unit use a suitable, solvent-free cleaner.
•
It is recommended to run the unit on a monthly basis in order to achieve best performance and output condition.
Before storing, run Beamz cleaner fluid through the system to help avoid condensing the pump or heater.
•
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Publicidad
