Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7. Insert the filter cage ⑧ into the dust canister and secure: align the three bosses on the filter cage
with the three slots within the dust canister and rotate the filter cage clockwise until locked.
8. Close the hinged cover ⑤ to lock.
9. The removal of the filter and its cage is done by releasing both with a counter-clockwise rotation
and reversing the assembly procedure.
10. Attach the telescopic wand ⑫ to the wand port ⑨ and the tool you require (⑬, ⑭ or ⑮).
USING THE APPLIANCE
1. Make sure that the vacuum cleaner has been properly assembled and with filters in place.
2. Choose the best tool for vacuum cleaning the specific surface. Optimum vacuum cleaning efficien-
cy is achieved by using the tools as follows:
- Hard floor & carpet tool ⑬: use it to clean carpets, rugs, and hard floors (like tiles or terrazzo).
- Slot tool ⑮: use it to clean narrow spaces.
- Small multifunctional brush ⑭: use it to clean curtains, upholstery, clothing, furniture or window
blinds.
3. Plug the power cord into a mains outlet and start the vacuum cleaner with the power switch ②.
CAUTION! This appliance is intended for cleaning of dry surfaces only!
4. Monitor the dust canister ④ level. When it is full, stop vacuum cleaning and empty the dust can-
ister. Working with the dust canister overfilled reduces the vacuum cleaner's performance (the
centrifugal force, which expels dust dirt into the duct canister, is reduced) and the filters become
clogged too fast.
5. If the suction power drops noticeably during vacuum cleaning
and the dust canister is empty, immediately check the wand and
the attached tool for obstruction.
6. You can also attach the tools directly to the motor unit's mouth.
This makes the vacuum cleaner more compact to clean places
which are hard to reach
7. When done, turn off the vacuum cleaner with the power switch
② and unplug the power cord from the mains.
EMPTYING THE DUST CANISTER
1. Turn off the vacuum cleaner with the power switch ② and un-
plug the power cord from the mains.
2. Hold the motor unit ① with the dust canister ④ directly above
the trash can
3. Press the hinged cover release ⑥ to swing open the cover ⑤ ,
then shake out all dust.
4. Close and lock the hinged cover ⑤ .
PARKING THE VACUUM CLEANER IN THE WALL
MOUNT
The MOD-34 vacuum cleaner includes a wall parking
mount ⑯ for easy and space-saving storage. Install the wall
parking mount on a wall to use it:
1. Choose a place on a wall high enough above the floor so that the
vacuum cleaner fits parked and with its telescopic wand and
18
.
Fig. 1
.
Fig. 2
❶
❷
Publicidad
