Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating Instructions
1. Follow all safety procedures and operation instructions outlined in the
edger manual.
2. Position an edger in front of the Edger Dolly. The edger should be in
front of the open end of the base frame. Secure the edger cord with
cord support of the Edger Dolly.
3. Sit on the seat cushion and lean forward on the chest pad.
WARNING: Do not sit on the chest pad. Only sit on the seat cushion
and lay your chest on the chest pad. Sitting on the chest pad could
cause the Edger Dolly to flip over.
4. Grasp the edger handles, but do not operate the edger. Adjust the
seat frame height and the chest pad position to the desired location.
WARNING: Do not over extend the chest pad. The maximum gap
between the chest pad and the seat cushion is 5", (12,7 cm).
5. Once the machine is properly configured, start the edger and assume
the operating position on the Edger Dolly.
WARNING: Electrocution or fire could occur if the edger is being
operated with a damaged power cord. Keep the power cord clear of
the edger and the Edger Dolly casters.
Storage and Transportation
1. Loosen the thumb screw and push the chest pad towards the middle
of the machine.
2. Remove the clevis pin and lower the seat frame to the bottom hole.
3. Utilizing the two hooks on the underside of the frame, the Edger Dolly
can be hung for storage or transportation.
CAUTION: Be sure to properly secure the Edger Dolly or any tool
before storing or transporting.
6
Publicidad
