CHAUFFAGE FRANCAIS LEXIA Mobile Euro Econom Manual De Operación Y Mantenimiento página 15

4.5 For using of the convector in mobile version set the supports and the handle as shown in
Figure 4.1 – 4.4.
Fig. 4.1
For install the supports, convector put on a horizontal surface ground up.
Observe the correct orientation relative to the convector when installing the supports. Be
careful, not to use excessive force to avoid breakage hooks of the supports.
Insert the hooks of the support (Fig 4.2) into the holes of the air intake grate convector so,
that the mounting holes coincided.
Fasten each support by screw (Fig. 4.3).
Set the convector in operational position (see Fig. 4.4).
Place the convector on supports in the room is similar (see Fig. 3). The distance from the
back wall of the convector to objects (furniture, curtains, etc.) must be at least 15 cm.
4.6 Set the key of the switcher (keys of the power regulator) to "0" position, set the handle
of the thermostat to  position. The convector is ready for operation.
5 ORDER OF OPERATION
5.1 Connect the convector card plug to the power socket. Pres the switch key to "I" position
(keys of the power regulator to "I"+"II" position). Set the handle of the thermostat to the scale
value close to the value – "6". Wait a few hours for the temperature to stabilize.
Fig. 4.2
1 - Handle of the thermostat
2 - Key of the switcher (keys of the power
regulator)
15
Fig. 4.3 Fig. 4.4