Descargar Imprimir esta página

Crunch GP800 Manual De Uso página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

VARIABLE BASS BOOST
By using the BASS BOOST controller [ 11 ] you are able to increase the bass enhancement from 0 to 12 dB.
ATTENTION: Use the BASS BOOST wisely!
PHASE SWITCH
The PHASE switch [ 12 ] allows to switch the phase from 0° to 180° to match the output signal with the vehicle's
interior acoustic.
VARIABLE LOW PASS FILTER
Set the desired crossover frequency by using the controller LOW PASS [ 13 ]. Thus to that only the frequencies
below the chosen crossover frequency will be amplified and the subwoofer plays more precisely and efficient.
BASS LEVEL REMOTE CONTROLLER
With the included bass level cable remote controller [ 14 ] allows to adjust the bass level e.g. out of the driver's
seat. Connect the remote controller and the REMOTE terminal [ 15 ] with the enclosed cable.
PROTECTION CIRCUIT
The POWER LED [ 16 ] lights up green, if the amplifier is in operation.
The PROTECTION LED [ 17 ] lights up red, when the amplifier is overheated, or a short circuit occurs respec-
tive a too low impedance load is connected to the speaker outputs. If this events, the internal built-in protection
circuit shuts down the amplifier automatically. The amplifier should work again properly after you have solved
the problems.
16
12
13
PHASE
LOW
PASS
POWER
180°
50Hz 150Hz
PROTECTION
OFF
ON
AUTO TURN ON
17
11
BASS
LEVEL
BOOST
INPUT
0dB
12dB
MIN
MAX
GP800
V2
ACTIVE SUBWOOFER SYSTEM
LOW LEVEL
INPUT
REMOTE
R+
R–
L+
L–
HI LEVEL INPUT
15
14
POWER
R
L
FUSE
GND
REM
+12V
11

Publicidad

loading