Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL OPERATING GUIDE
WIRELESS REMOTE CONTROL FOR
7000KI • 7500KI • 7500KIT • 7000KI40 • 7500KI40 • 7500KI40T
FAN ON & POWER OFF - Press this button:
• To start the fan
• To turn the fan off
• To exit Auto Mode
VENT LID POSITION - Press this button to open or close the vent lid
• While the fan is running in Manual Mode press once to close the vent lid and
enter "Ceiling Fan" Mode.
NOTE: This button is not active in Auto Mode. If the fan loses 12volt RV
power or power is removed from the fan, use the knob located at the ceiling
to manually open or close the vent lid if desired.
AIR EXHAUST / INTAKE - Press this button to reverse the fan from
intake or exhaust
NOTE: In Auto Mode, the fan direction is automatically positioned to Exhaust,
but may be overridden and changed to Intake by depressing this key.
FAN AUTO MODE - Press this button to enter Auto Mode
• Auto Mode allows the fan lid to automatically open and the fan motor to
operate as dictated by the thermostat set point temperature. Once the cabin
temperature cools and reaches the set point temperature, the fan lid will close
and the fan motor will shut off.
• Pressing this button while in Auto Mode will shut off Auto Mode, close the vent lid
and shut off the fan motor.
THERMOSTAT SET TEMPERATURE
TEMP + ~ Press this button to increase the Set Temperature for Auto Mode.
TEMP - ~ Press this button to decrease the Set Temperature for Auto Mode.
NOTE: The thermostat temperature range is from -2°C to 37°C. To change from Celsius to Fahrenheit
on the temperature display, press and hold both set temperature keys simultaneously.
FAN SPEED
Fan Speed UP ~ Press
this button to increase
the fan speed. The fan
has ten speeds.
Fan Speed - ~ Press this
button to decrease the
fan speed. The fan has
ten speeds.
NOTE: When the fan
speed reaches either the
maximum or minimum
speed,
the
respond with 2 quick
beep sounds to indicate
this.
LOW BATTERY
INDICATOR
• When the battery is at full charge, three black power bars are displayed.
• One or zero power bars displayed indicates the batteries need replacement.
TRANSMISSION SIGNAL
• This symbol is displayed on the screen when any button is pressed to indicate the signal was transmitted
to the fan.
• A beep sound from the ceiling unit indicates the signal from the remote control was received by the fan.
MAXXFAN
®
SET
TEMPERATURE
AUTO MODE
INDICATOR
FAN ON
INDICATOR
fan
will
FAN OFF
INDICATOR
Deluxe MODELS
TRANSMIT
CEILING FAN
FAN SPEED
CEILING FAN MODE
7
Remove protective film from
Display Screen
LOW BATTERY
INDICATOR
ROOM
TEMPERATURE
VENT LID IN
AUTO MODE
VENT LID
POSITION
AIR DIRECTION
INDICATOR
Publicidad
