Publicidad
Idiomas disponibles
Idiomas disponibles
5.3
DVR WEB CONNECTION
Your DVR can be reached on the Internet (with or without DDNS) only if the Internet service supplier assigns a public IP
address (static or dynamic) to the router. It is therefore advisable to check this crucial detail with your Internet provider
beforehand.
1.
DVR network parameter setup
The URMET DVR network configuration is DHCP mode by default (automatic IP address allocation):
a)
If the network to which DVR is connected supports DHCP, simply display the parameters that the DVR
acquires automatically from the network in "Menu
parameters to be allocated and appear automatically in the menu: IP address, subnet mask, gateway and
DNS (see below).
Press APPLY to save the changes.
b)
The DVR parameters must be allocated manually if the network does not support DHCP. Select "Type =
Static" on the "Menu
DNS.
Press APPLY to save the changes.
IMPORTANT NOTE:
The DNS fields must be filled in correctly for correct operation of the DDNS system.
2.
Port setup
At this point the external doors of the router must be forwarded to the DVR. The function is usually called "Port-
forwarding" or "Virtual Server" in the router configuration menu. The ports set on the router must correspond to those of
the DVR.
a)
Set different values on the DVR if the default ports of the DVR (80, 9000, 18600) are already in use in the
port-forwarding table of the router.
DS1093-144
All manuals and user guides at all-guidesbox.com
Network". Wait for ten seconds or so for the
Network" and fill in the following fields: IP address, subnet mask, gateway and
45
Publicidad
