Publicidad
Idiomas disponibles
Idiomas disponibles
02 TV Installation
One Invisible Connection Guide
TV
To connect the One Invisible Connection to the One Connect and your TV, follow these steps:
1. After the TV is completely set up and placed in its final position, connect the One Invisible Connection to the One
Connect and the TV as shown in Steps 1 to 4 above.
WARNING: Make sure that both connectors are fully and firmly connected. If either connecter is not connected
properly, there is a danger of severe electric shock.
2. Connect the One Connect AC power cord to the One Connect, and then connect the cord to a wall outlet as shown
in Step 5 above.
WARNING: Follow the directions exactly. Be sure to connect the power cord to the wall outlet as the last step.
Always disconnect the power cord from the wall outlet before disconnecting the One Invisible Connection from
the back of the TV or from the One Connect.
– See the illustrated Quick Setup Guide for more information.
3. Connect your peripherals (antenna, cable box, Blu-ray player, etc.) to the One Connect. See the Accessory Kit Guide
for details.
• Do not install the One Connect upside-down or standing upright on one of its sides.
• When connecting the One Invisible Connection, use a Bending Cover to bend the cable. The Bending
Cover prevents the cable of the One Invisible Connection from being bent at a 90 degree angle. Bending
the cable at a 90 degree angle can damage the cable.
• When connecting the One Invisible Connection, pay attention to the shapes and sizes of its connectors so
that they are connected correctly. Failure to do so may cause product malfunction.
• When connecting the One Invisible Connection, be careful not to twist the cable of the One Invisible
Connection. Failure to do so may cause performance degradation of the TV or damage to the cable.
• When arranging the remaining cable, refer to the figure above for the correct arrangement.
• Take care not to subject the cable to any of the actions below. The One Invisible Connection contains a
power circuit. You could damage the cable and subject yourself to an electric shock.
• Handle the One Connect carefully. It is heavy.
Bending
English - 8
x 1
(M4 x L12)
Bending Cover
Twisting
Pulling
ONE CONNECT
5
ONE CONNECT
4
4 inches
10 cm
Pressing on
ONE CONNECT
ONE CONNECT
Electric shock
Publicidad
