Rowlett DE205 Manual De Instrucciones página 7

Descaling program
In hard water areas limescale can build up within the appliance after prolonged use. For best taste and
extended appliance life, descale it regularly. Installation of a water filtration system is also recommended.
IMPORTANT:
• Failure to descale or maintain will invalidate your guarantee.
• Always use a suitable descaler for coffee machines and follow the manufacturer's
instructions on the container.
1. Immediately after turned on, if both coffee and tea buttons flash quickly, the appliance needs to
descale. Turn the appliance off immediately.
2. Remove the water tank and fill with descaling solution (water and descaler ratio: 4:1).
3. Put the water tank back into position. Then place a container on the drip tray. Ensure the Lever is
pushed down fully and no capsule is present.
4. Turn on and wait for the coffee and tea buttons to stop flashing. Press both buttons firmly at the
same time and hold for 5 seconds. Both Buttons will now quickly flash.
5. Press the Coffee Button to start descaling. Your machine will dispense. This will continue until the
Water Tank is empty. Wait 10 minutes for the Descaling Solution to take effect.
6. Rinse the Water Tank and fill with fresh water. Repeat step 5 (Dispense) and flush at least two full
tanks of water through the system to remove any traces of the Descaling Solution.
Note: If turned off in descaling mode, the appliance will stay in this mode when switched
back on. To exit the mode, press both Coffee and Tea Buttons at the same time and hold for
5 seconds. Both lights will go back to solid illumination.
7. The appliance is now ready for use again.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The unit is not working
Loud noise emitted
Indicator lights come on
but no coffee/tea out
Water beneath the unit
Capsule fails to go
into capsule holder or
capsule basket
DE205_ML_A5_v3_20230526.indb 7
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains Power supply fault
No water in water tank
Capsule inserted may be faulty
There will be a small amount of condensation underneath the machine after
making numerous beverages. This is safe and does not mean any leakage
Water tank may not be seated
correctly
Capsule basket is full
Lever not lifted fully
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the plug fuse
Check Mains Power supply
Turn Off and refill
Wait a few seconds, then try again with a
new capsule
Check and locate in place
Empty the basket
Lift the lever fully
EN
7
2023/5/26 16:02:19