Publicidad
Idiomas disponibles
Idiomas disponibles
5. A) Attach one LH short Hinge & Mounting Bracket Assembly (#18) using four Screws (#15) as shown in
DETAIL C. Attach one RH short Hinge & Mounting Bracket Assembly (#6) using four Screws (#15) as
shown in FIGURE 5. Attach two Long Hinge & Mounting Bracket Assemblies (#5) using eight Screws
(#15) as shown in DETAIL D & FIGURE 5.
B) Attach LH short Hinge & Mounting Bracket Assembly (#18) and RH short Hinge & Mounting Bracket
Assembly (#6) to U-Leg (#1) using two Bolts (#17) with two Thick Flat Plastic Washers (#33) and two
Locknuts (#19) as shown in FIGURE 5 and DETAIL C. DO NOT OVERTIGHTEN hinge must pivot.
Note: 1/8" Thick Plastic Washer (#33) goes between Hinge and Leg.
REPEAT STEPS 4-5 ON THE OTHER ALUMINUM TOP ASSEMBLY.
CAUTION: Hinges must be positioned
exactly as shown or table will not operate
correctly and could be damaged.
Do not overtighten nuts, hinge must pivot.
33
(Thick Washer)
33
All manuals and user guides at all-guides.com
Parts Needed:
1 pc - #6 RH short Hinge & Mounting Bracket Assembly
1 pc - #18 LH short Hinge & Mounting Bracket Assembly
2 pcs - #5 Long Hinge & Mounting Bracket Assembly
Hardware Needed:
16 pcs - #15 Phillips Rd. Hd. Screw
2 pcs - #17 Phillips Rd. Hd. Bolt
2 pcs - #19 Locknut
2 pcs - #33 Flat Plastic Washer (1/8" Thick)
6
15
5
Publicidad
