PNI C130 Manual De Usuario página 6

Usage instructions
1. In standby mode, if no operation is registered for 30 seconds, the device
automatically enters hibernation mode (sleep). Briefly press the SET and
EXIT keys to reactivate the device.
2. Press the STD/M mode key to select the battery type: STD, AGM and Li
(Lithium). The corresponding LED indicator will light up.
3. Press the Up and Down keys to select the corresponding icon, then press
the SET key to confirm.
4. Press the Up and Down keys to select the charging mode, press the key
corresponding to the selection, press the Up key, switch to Cycling mode,
press the SET key to confirm, then press the EXIT key to exit and return
to the main interface.
5. After the user connects the 12V battery and enters charging mode
through the settings interface, the F02 icon appears on the screen. At
this moment, the voltage is too low. Long press the Up key to enter the
forced charging mode. If you have selected the Lithium battery type,
long press the Up key to enter the OV startup mode.
6. Activation process of Lithium batteries:
• Press the STD/M mode key, select Li (Lithium) battery type. The
corresponding LED indicator will light up.
• Press the Up and Down keys to select the charging mode, press the SET
key to confirm. Long press the AUTO CHARGE key for 5 seconds until
the MEM icon appears on the screen. At this moment, the battery has
been activated.
• Press the EXIT key to switch to normal charging mode.
Battery charging
1. Press the AUTO CHARGE key to charge the battery after the previous
charging mode. The charging current is 2A - 12A.
2. Charging is complete when 100% appears on the screen.
3. Long press the AUTO CHARGE key to enter the power supply mode
(voltage source). The output voltage is 13V 4A.
User manual 6