Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
Not enough
heat or Too
heat
No steam or
Leakage
No burst of
steam or
tion has been used too often within
no vertical
steam
Leaking
water from
Soleplate
The water is over than max position Pour out the remaining water
Little Steam
Guarantee
This product is guaranteed against defects in materials and workmanship for a period of
two years from the date of purchase. Under this guarantee the manufacturer undertakes
to repair or replace any parts to be defective, providing the product is returned to one of
our authorised service centres. This guarantee is only valid if the appliance has been used
in accordance with the instructions, and provided that it has not been modified, repaired
Possible Reasons
Rotate thermostat dial improperly
or unplugging
The thermostat dial has been set
to MIN
The (vertical) burst of steam func-
a very short period. The iron is not
hot enough
Set the thermostat dial out of
steam range
The heat is still not enough
Check if the steam selector is in
proper location
Steam hole is blocked
Poca agua en el depósito
Measurement
Correct Thermostat dial in
position and check if the iron
is plugged
Set the thermostat dial to the
required position
Continue ironing in horizontal
position and wait a while befo-
re using the (vertical) burst of
steam function again
Set the thermostat dial as per
steam range
Open steam button only after
the indicator light goes off
Set the steam selector to the
proper location
Clean hole with distilled water
Llenar de agua el depósito
Publicidad
