Publicidad
Idiomas disponibles
Idiomas disponibles
TCR SETUP:
With the device turned off, hold the power button and + button for five seconds.
Once you have entered the TCR menu, press the + or - button to choose a memory.
You will then press the power button to enter your parameter setting. Press the + or -
button to set the parameter for your atomizer. Then hold the fire button to confirm.
BYPASS MODE:
Bypass Mode is a direct output mode of voltage. This mode can only be used with
atomizer resistances under the range of 0.15-3.5 ohms; otherwise the device will not
work properly. Press the power button three times to enter the menu. Press the + until
you enter bypass mode and press the power button to confirm.
EXTRA FEATURES:
1. NEW COIL/SAME COIL PROMPT
When replacing your atomizer, especially from a nickel atomizer to a temperature
controlled atomizer (Ni, Ti, SS 316), you will be required to reset the resistance of that
atomizer. This helps the device recognize that the new atomizer is to be used at room
7
www.vaporfi.com
Publicidad
