Troy-Bilt Vortex 3090 XP Manual Del Operador página 8

Chute Assembly
1. Remove hairpin clip, wing nut and hex screw from chute
control head and clevis pin and bow-tie cotter pin from
chute support bracket. See Figure 3-3.
Chute
Chute Base
2. Insert chute control rod into chute control head. Push rod
as far into chute control head as possible, keeping the holes
in the rod pointing upward. See Figure 3-4.
8 S 3— A
ection SSembly
Chute Control Head
Chute Support
Bracket
Figure 3-3
Figure 3-4
& S -U
et p
3. Place chute onto chute base and ensure chute control rod
is positioned under the handle panel. Secure chute control
head to chute support bracket with clevis pin and bow-tie
cotter pin removed in step 1. See Figure 3-5.
Figure 3-5
4. Finish securing chute control head by installing hex bolt
and wing nut. See Figure 3-6.
Figure 3-6