Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Do not grasp control panel to move compactor. Slide compactor onto cardboard or hardboard before moving compactor
across floor to prevent damaging floor covering. Do not allow the rear frame of the compactor to touch the floor covering when lifting or
moving compactor.
Assemble Caster Frame and Install the Compactor on the Caster Frame
1. Locate the caster frame
C
A. Caster frame
B. Closed end of caster frame (with lip)
C. Open end of caster frame (without lip)
Locate included caster frame. Set it on the floor with the lip
facing down.
3. Install the fixed casters
D
A. Swivel casters
B. Fixed casters
Install the (2) fixed casters to the front (open end) of the frame
assembly with (4) bolts and nuts.
IMPORTANT: Do not grasp control panel to move compactor.
Move the compactor to its final position. Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so
drawer will go over drawer stops. Close the drawer. Check that drawer opens freely. If the toe plate rubs against floor, see "Adjusting the
Toe Plate" for further instructions. Plug into a grounded 3 prong outlet.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:
Mark on each side of the toe plate the amount of toe plate that rubs the floor covering. Remove the drawer from the unit. See Step 3 in
the "Unpacking" section. Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate. Use scissors or
utility knife to cut toe plate along line. Replace drawer. If toe plate still rubs floor covering, repeat steps 1 through 4.
Install the Casters
A
B
A
B
C
C. Open end of frame assembly
D. Closed end of frame assembly
Install the Compactor
(optional)
2. Install the swivel casters
Install the (2) swivel casters to the back (closed end) of the frame
assembly with (4) bolts and nuts.
4. Install Compactor On Caster Frame
To keep the caster frame from moving during the initial
installation, block the wheels or place frame against a wall. Lock
the back casters in place by pushing the locks down. Tilt the
back of the compactor forward and push the compactor up onto
the caster frame assembly over the open end of the frame. Slide
the compactor all the way back until it touches the back lip of
the caster frame assembly.
Wall
5
Publicidad
