Publicidad
Idiomas disponibles
Idiomas disponibles
8. TOOL OPERATION
Attaching the Bits (Bits excluded)
1. Insert the bit into the hole of the driver shaft.
2. To remove the bit, pull it out from the bit holder.
Tool Operation
1. How to insert and remove bit:
To remove a bit from the chuck, hold the "B" part firmly by one hand and turn the "A" part by
counterclockwise.
To insert a bit into the chuck, hold the "B" part firmly by one hand and turn the "A".
Remove the bit
Turn clockwise
2. Forward / Reverse Rod selection button.
Select the forward or reverse direction of the tool by pushing the Forward / Reverse Rod.
High/Low speed selection:
– Use the "High" for drilling application.
– Use the "Low" form screwdriver application.
3. Select the applied torque.
Use the 10 sections adjustment ring to select the right torque you're your application.
4. Drill model:
Select the torque ring to the
make a drill on wood.
Replaceable Carbon Brush
1. Replace the new carbon brush, while the motor is not rotated and the carbon brush is run
out.
(Change the new motor after the carbon brush has been replaced 2~3 times).
2. How to replace carbon brush:
A. Use screwdriver to disassemble the screw from rear cover of the housing, then take out
carbon brushes from both right and left sides. (See Fig. 1)
Select the speed by pushing
the High / Low Speed Rod
Low speed
(For screwdriver)
A
B
sign for the maximum torque position if you would like to
•
9
9.5 mm (3/8") - 11.5 mm (7/16")
High Speed
(For drill)
Forward/Reverse Rod
•
6.35 mm (1/4")
Publicidad
