Car Shades HON-FRV-5-A Manual Del Usuario página 4

REAR DOOR
Installing the Clip
1. Open the left rear door.
2. Check the positions where the clip are installed
and clean the surfaces with the cleaner provided
from the kit.
CLIP INSTALLATION POSITIONS (4)
• Clean the surface with a cleaner.
3. Measure each clip installation position to the
dimensions shown.
4. Mark with a felt-tip pen the position of the
measured dimension of the door sash.
Make marks as marks
with felt-tip pen as
shown.
30 mm
LEFT REAR
DOOR SASH
30 mm
Make marks as
marks with felt-tip
pen as shown.
All manuals and user guides at all-guides.com
LEFT REAR DOOR
5107032H
50 mm
Make marks as
marks with felt-tip
pen as shown.
Make marks as
marks with felt-
tip pen as shown.
30 mm
6709030T
5. Remove the adhesive backing from each clip.
6. Align the edge of the clip with the mark on the door
sash, and attach the clip on the sash.
• Hold the adhesive tape of the clip back side
firmly against the door sash for 15 seconds
after attaching the clip.
Align the edge of the
clip with the mark
made in the step 4.
ADHESIVE
BACKING
• Remove.
CLIP
DOOR
SASH
Align the edge
of the clip with
the mark made
in the step 4.
CLIP
7. Repeat the procedure to install the clip on the right
side.
4
DOOR
GLASS
Align with the
CLIP
end of the
radius.
DOOR
GLASS
Align with the end
of the radius.
6709040T
© Honda Access Europe NV. 2006