Vonyx STM3400 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
FRONT PANEL
1. SD CARD SLOT: Insert an SD card in this slot.
2. DISPLAY: The display shows multiple forms of information, for example current MODE, elapsed time, etc.
3. BT LED LIGHT: When BT mode is enabled, this LED will light up.
4. USB PORT: You can play media files from a USB device by connecting the device to this slot.
5. BUTTON CLUSTER:
MODE BUTTON - Press to change modes between playing SD, USB, MP3 and BT.
PLAY / PAUSE - Press this button to start or pause play.
FOLDER - Press this button to enter FOLDER selection.
REPEAT MODE - Press the repeat button once to continually repeat ALL tracks, press repeat once more to repeat just the
current track.
PREVIOUS - Press this button to go to the previous track. Press and hold to scan backwards within tracks.
NEXT - Press this button to go to the next track. Press and hold to scan forwards within tracks.
6. INPUT SELECTOR: There are 2 different input positions: line and USB.
7. MICROPHONE TALKOVER: This function allows you to lower the level of the input channel(s) when talking trough a
microphone.
8. CHANNEL 1 AND 2 FADERS: Adjust the volume of channel 1 & 2.
9. VU-METER (OUTPUT): The LED display shows the level of the left and right master output.
10. CUE: Allows you to monitor the music through the headphones for the selected channel.
11. MICROPHONE LEVEL CONTROL: Adjust the volume of the microphone signal.
12. CROSSFADER: Use to fade between channels 1 & 2.
13. HEADPHONES LEVEL CONTROL: Adjust the volume of the headphones signal.
14. TIME: When activated, you can use the jog wheel to adjust the value of the X parameter (time) of the effect generator.
15. RATIO: When activated, you can use the jog wheel to adjust the value of the Y parameter (mix ratio, resonance or
feedback) of the effect generator.
16. BYPASS: Press to choose or cancel DJ effects. When choosing effects, "DJ" will be displayed. When effects are canceled,
"BYPASS" will be displayed.
17. EFFECT DISPLAY: The display shows multiple forms of information, for example current effect, ratio, bypass etc.
18. EFFECT SELECTOR: You can change between 16 DJ effects: Flanger, Flanger Verb, Phaser, Robot Flanger,
Pitch, Scratch, Analog Delay, Trans, PhaseWah, Filter, AutoWah, SmallHall, Thinplate, Plate, LPF Reverb, Gated Reverb.
19. JOG WHEEL: The jog wheel has 2 functions:
In SCRATCH mode
Select the "SCRATCH" DJ effect (no. 6) with the effect selector to activate scratch mode. Now use the jog wheel to produce
scratch sounds.
In PARAMETER mode
TIME BUTTON (X parameter) – When the time function is activated, you can use the jog wheel to adjust the value of the X
parameter (time) of the effect generators.
RATIO BUTTON (Y parameter) – When the ratio function is activated, you can use the jog wheel to adjust the value of the Y
parameter (mix ratio, resonance or feedback) of the effect generators.
3