Descargar Imprimir esta página

SNOWJOE HJ604C Manual Del Operador página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

m
CAUTION!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the grass shear + hedge trimmer plugged into the charger.
Switch off or unplug the charger at the mains when charging is
complete.
NOTE: The charge level indicator LED light will illuminate red
when the charger is plugged in and is charging the grass shear
+ hedge trimmer. The middle LED light will turn green when the
grass shear + hedge trimmer is fully charged.
The charging process starts as soon as the charger is plugged
into both the proper electrical outlet and the tool.
• During the charging procedure, the handle of the tool will
feel slightly warm to the touch. This is normal.
• When no further use is planned for an extended period of
time, disconnect the battery charger from the outlet and the
unit.
• Do not use the tool during the charging procedure.
Battery Charging
The length of service between each charging varies depending
on the type of work you are doing. The battery in this grass
shear + hedge trimmer has been designed to provide
maximum trouble-free life. However, like all batteries, it will
eventually wear out. To obtain the longest possible battery life,
we suggest the following:
• Store and charge your grass shear + hedge trimmer in
a cool area. Temperatures above or below normal room
temperature will shorten battery life.
• Never store the grass shear + hedge trimmer with the
battery in a discharged condition. Recharge the unit
immediately after it is discharged.
• All batteries gradually lose their charge. The higher the
temperature is, the faster they lose their charge. If you
store your grass shear + hedge trimmer for long periods of
time without using it, recharge the battery every 6 months.
This will extend battery life.
NOTE: The grass shear + hedge trimmer has been shipped in
a low charge condition and should be fully charged before use.
1. Plug the charger adaptor into an appropriate AC power
outlet. Connect the AC adaptor charger plug into the
charging socket of the grass shear + hedge trimmer to
start charging (Fig. 9).
Fig. 9
2. LED no.1 will illuminate red when charging. LED's 2 and 3
will not illuminate when charging (Fig. 10).
Fig. 10
3. The battery will take approximately 3 hours to charge.
Charging may take up to 5 hours due to the level of
charge left in the battery and the ambient temperature.
NOTE: A charge level indicator LED light will always be
illuminated when the charger is plugged in and the mains
power is turned on. The charge indicator indicates the charge
status of the grass shear + hedge trimmer as shown below:
Colour of
Condition
LED's
Charging
Red
Fully
Green
Charged
Low Charge
Yellow
Operation
IMPORTANT! The product is intended for light-duty trimming
of shrubs and lawn edges for residential properties.
NOTE: Charge the battery for 3 to 5 hours then use it until it
runs down (i.e. the tool will only slowly operate and the yellow
charger indicator will be illuminated). Recharge for 3 to 5 hours
again before resuming operation.
m
WARNING!
The blades continue to move for a few
seconds after the tool is switched OFF. Turn OFF the tool and
wait until the blades come to a complete stop before adjusting
or cleaning.
m
CAUTION!
Never touch the blade or blade rail while
the tool is in operation and be aware of the sharp edges even
when the grass shear + hedge trimmer is not in use.
8
1
2
3
LED's Illuminated
1- Red, 2- Not illuminated,
3- Not illuminated
1- Not illuminated, 2- Green,
3- Not illuminated
1- Not illuminated,
2- Not illuminated, 3- Yellow

Publicidad

loading