Zeegma Cure Manual De Usuario página 8

CHARGING
EN
Make sure the device is fully charged before first use. Charging takes
approximately 3-4 hours.
Insert one end of the power cable (9, fig. A) into the charging port
(10, fig. A) and the other end into the charger (not supplied), then
connect the device to the power source. During charging, the battery
level indicator (8, fig. A) will flash.
Before charging, the device must be switched off using the main
switch.
Do not charge the device in an environment with high temperatures
and/or humidity, or in direct sunlight.
It is recommended to recharge the device when the battery level
drops to 20%. The battery level is displayed on the control panel
(2, fig. A) and on the battery monitor (4, fig. A).
USE
1.
Choose the right tip to suit the part of the body to be massaged
(see: Massaging tips).
2.
Insert the desired tip and press down firmly (fig. 1). To remove
the tip, pull (fig. 2). When removing the tip, do not rotate it.
3.
Switch on the device by moving the main switch (11, fig. A)
from the OFF to the ON position.
4.
Start the device with a single touch of the switch (6, fig. A)
located on the touch control panel (2, fig. A).
5.
Select one of the seven speed levels (7, fig. A) by pressing
the switch (6, fig. A) again. The speed level will increase when
a stronger pressure is applied.
6.
To switch the device off, press and hold the on/off switch (6,
fig. A) and then move the main switch (11, fig. A) from the ON
to the OFF position.
Note! Massage of a given body area should not last longer than 1
minute. The device will automatically switch off after 10 minutes
of continuous operation to avoid overheating of the motor and
batteries. To resume operation, press the switch.