LUMIT SIRLA A22980120B Manual De Instrucciones página 3

INSTRUCTION MANUAL
SIRLA
REF. A22980120B
A
B
②
2
GENERAL SAFETY INFORMATION
_____________________________________________________________________________
To reduce the risk of death, personal injury, fire, electric shock,
>
falling parts, cuts / burns and other hazards, read all warnings and
instructions included with the appliance box as well as all labels.
Before installing or maintaining this equipment, follow the
>
instructions in this manual. For a residential installation, if you
are unsure whether to install or maintain the luminaire, consult a
licensed and qualified technician.
DO NOT INSTALL THE PRODUCT IF THE SAME IS DAMAGED
>
To prevent injury or damage to the assembly of this product,
>
make sure the conductors and screws are secure before connecting
the power.
Young children should be supervised to ensure that they do not
>
play with this product.
Handle the installation carefully to avoid any damage or breakage.
>
For installation, select an appropriate location away from liquids
>
and hazards. Make sure that the connection does not come into
contact with corrosive materials or surfaces, chemicals, etc.
Turn off the power and let it cool before cleaning. To clean, use a
>
clean, damp cloth. Never immerse the appliance in water.
Lamp replacement and maintenance: disconnect power and allow
>
fitting to cool down before cleaning or replacing.
Check that the supply voltage is correct compared to the
>
informative label of the luminaire.
INSTALLATION INSTRUCTIONS
_____________________________________________________________________________
1. Make sure the power supply is turned off.
2. Remove the screws and washers of both sides to release the
lamp base (1).
①⑤
1 5
OFF
③
3
4
3. Put the lamp base on the fixing place and pass the cables through
the central hole (2).
4. Put the screws into the plugs in order to fix the lamp base (3).
5. Connect the wires of the fixed wiring respecting the instructions
given: connect the live conductor to terminal L (brown color),
the neutral conductor (blue color) to the N terminal and the phase
conductor (green/yellow) to the ground terminal.
Avoid electric shock.
6. Fix the lamp body onto its base with the scresw and washers (5).
7. Turn on the switch.
IMPORTANT
_____________________________________________________________________________
Ensure that:
1. The screws are tight
2. Connections are correct. If in doubt, consult a qualified technician.
3. The connector is well placed. In case of doubt, consult a qualified
technician.
Repair and maintenance (consult a qualified technician):
When the LED does not work, replace it: disconnect and remove
the screws from the power. Replace with new LED. Make sure the
connections are correct.
When the LED driver does not work, replace it: remove the LED
driver and cut the cable with scissors. Connect the cable with the
new one and place it on the board.
> The light source and independent control device can be removed
by qualified person without permanent damage to the whole lamp.
> This product contains one light source of energy efficiency class
F.
[ EN ]
C
ON
2