Wireless Lan Module (Option); Wlan Driver Installation; Wlan Configuration - Clevo P370SM Manual Del Usuario

Wireless LAN Module (Option)

Make sure the Wireless LAN module is turned on (and not
in Airplane Mode).

WLAN Driver Installation

Follow the instructions below:
WLAN/WLAN and Bluetooth Combo (Intel)
1. Click Option Drivers (button).
2. Click 1.Install WLAN Driver > Yes.
3. Click Next > Next.
4. Click the button to accept the license and click Next.
5. Click Typical (buttom) or Custom (buttom).
6. Click Install > Finish.
WLAN and Bluetooth 4.0 Combo (Third Party)
1. Click Option Drivers (button).
2. Click 1.Install WLAN Driver > Yes.
3. Click Next.
4. Click Finish to restart the computer.
WLAN and Bluetooth 4.0 Combo (Qualcomn Athros)
1. Click Option Drivers (button).
2. Click 1.Install WLAN Driver > Yes.
3. Click Next > Yes > Next.
4. Click Install > Yes to restart the computer.

WLAN Configuration

Make sure the Wireless LAN module is turned on (and not
in Airplane Mode) before configuration begins.
1. Go to the Charms Bar.
2. Select Settings and then click the WiFi icon (it should read
Available under the icon and Airplane mode should be Off).
3. A list of available access points will appear.
4. Double-click an access point to connect to it (or click it and click
Connect).
5. Enter a network security key (password) if required, and click
Next.
6. You can choose to share or connect to devices or not.
7. When you are connected to the network access point it will
display the Connected icon.
8. Select any connected network and click Disconnect to
disconnect from a connected access point.
9. You can click the Airplane Mode button to turn the mode On or
Off.
10. If you click on Change PC Settings (at the bottom of Settings
in the Charms Bar) you can turn Wireless or Airplane Mode
On/Off.
11. You need to either use Airplane Mode, or to turn the WLAN
module off aboard aircraft.
29