Portamate PM7000 Manual Del Operador página 7

Using the Material Stops
15. The roller supports have built-in flip stops that can be used for repetitive
cuts or the same length. Simply flip the stops into the up position and
adjust to the desired length. Figure 10.
Transporting and Storing
16. Before storing or transporting, make sure all attachments are secured.
Collapse outrigger supports. And it is recommended that benchtop tools
are removed.
17. To fold legs, lift up on one end of WorkCenter with handle and depress
the leg-locking snap buttons. Pivot collapsing legs until the snap button
engages to hold the leg in the closed postion. Repeat on the other end.
Kit No. J-104
Mounting Kit for Miter Saws and/or Other Power
Tools with an Inset Mounting Hole Pattern
Kit No. J-210
Mounting Kit for Miter Saws and/or Other Power Tools
with 3-Hole Mounting Pattern
Comes with everything above and adds bracket (Part #J105)
which connects both #3040 Offset Mounting Brackets.
Instructions
Secure Offset Mounting Brackets as shown above.
Note: Brackets can be used on the front or rear of the Machine Mounts.
To Order (if not included) Call:
1-800-624-2027
Using Your PM7000 as a Woodworking Center
Your PM7000 Miter Saw WorkCenter can be used with many benchtop tools
such as table saws, belt/disc sanders, bench grinders, planers, bandsaws,
scroll saws and more.
Figure 10
X
Y
Z
7
W
#3040
Parts List
#3040 Offset Mounting Bracket
W 5/16"-18 X 3/4" Carriage Bolt
X 5/16" Flat Washer
Y 5/16" Spring Type Lock Washer
Z 5/16"-18 Hex Nut