Adler europe AD 4130 Manual De Uso página 9

22. WARNING: Be careful when handling the blades
cutting blades, when emptying and cleaning the machine.
23. WARNING: Always unplug the appliance when left unattended and before assembling
or disassembling or cleaning.
24. WARNING: Do not use the equipment if the rotating blades are damaged.
25. WARNING: Before replacing equipment or approaching parts that move during use,
switch off and disconnect equipment.
26. Only use accessories provided by the manufacturer.
27. When the device is operating, do not put your hand or any objects into the feeder
opening. Only use the pusher for this purpose.
28. Meat should be inserted into the feeder opening while the device is operating, it is not
allowed to fill the feeder opening with fruit or vegetables when the device is stopped.
29. Be careful not to overload the machine, do not use too much force to push the products
through the feeder.
30. Always disconnect the device from the mains when it is not in use or you want to clean
it.
31. Do not disassemble the clipper while it is plugged into a power outlet.
32. Do not use harsh scourers or abrasive cleaners for cleaning.
33. Do not immerse the motor unit in water or any other liquid.
Slow Juicer AD 4130 / AD4131
Main Product Unit
1. Power cord with plug
3. Swing Switch
Extraction function
5. Juice cup
8. Extraction pusher
11. Extraction screw
Meat grinder Function (Only in AD4131)
14. Pusher for meat grinder
17. Feeding screw
20. Cutting disc 5mm
23. Sausage attachment
Salad maker (Only in AD4131)
24. Salad maker pusher
26. Salad maker tube cover
28. Shredder
Before first use:
1. Before first use remove all packaging material.
2. Clean the device and all attachments with warm water mixed with dish washing soap.
3. Dry with a dry and soft towel or paper towel.
Button description:
The device has 1 rocking switch to operate.
The 3 functions of the switch are as follows:
I : This turns on the device. After pressing it will continue working until turned off.
O : Off position. The device will be turned off when the switch is in this position.
R : Reverse. When pressed the engine will turn into reverse. The Auger/slicer will turn in the opposite direction compared to normal
operation. When released the device will switch to Off position.
Juice Extractor Models AD4130 and AD4131 :
Couple Extractor to Frame. (Picture E. Page 3)
Embed the extractor into the frame by aligning the center on the inlet with the triangle mark (to point at the three fasteners on the
extractor). (Picture E. Page 3)
Then rotate the extractor counterclockwise till it clicks. (Picture E. Page 3)
Align the hexagonal shaft of spiral propeller with the hole in the frame and push it in to the end. (slightly rotate the spiral propeller to
make good alignment) (Picture F,G. Page 4)
Insert the coarse-hole end of juice filter into tail of spiral propeller and lock the three fasteners into the three slots in the extractor
Mis-align the three fasteners on extractor cover with the three ones on extractor and horizontally push them in, and then attach the cover
to the extractor by rotating it counterclockwise. (Picture H. Page 4)
Place juice container beside machine frame with its opening right below the frame outlet. (Container baffle should be mounted in the
2. Engine unit
4. Locking ring
6. Foam filter plate 7. Pulp cup
9. Juice tray
12. Filter net
15. Food tray
18. Cross knife
21. Cutting disc 8mm
25. Salad maker tube
27. Slicer
29. Masher
10. Squeezing tube
13. Extraction cover
16. Feeding tube
19. Cutting disc 3mm
22. Fixing ring
9