Publicidad
Idiomas disponibles
Idiomas disponibles
1.
CAUTION Do not let the cooktop drop into place.
Make sure that the cooktop is supported along the
▶
edges when carefully placing it into the cutout.
Turn the cooktop over carefully making sure not to
damage the pressure regulator and gas line.
Place the cooktop carefully into the countertop
‒
cutout, pulling it towards the front of the cutout .
Lower the rear of the cooktop so that is rests flat on
‒
the counter .
Center the cooktop left and right in the cutout .
‒
Rotate the hold-down brackets so that they will contact
2.
the underside of the countertop.
Hand-tighten one hold-down bracket and check the
‒
cooktop position, then secure the cooktop by
tightening all the brackets. Do not over-tighten.
The orientation of the hold-down brackets depends
‒
on the thickness of the countertop.
a
Cooktop
b
Countertop
Note: Do not use silicone to glue the cooktop to the
countertop surface.
4.4 Connection overview
Refer to this illustration for the location of the gas and
electric connection of the appliance.
Note: Your appliance is equipped for use with natural gas
on delivery. If you want to use your appliance with LP gas
refer to the section on LP gas conversion before
continuing with the installation.
a Cooktop rough-in box
b Arrow on pressure regulator, shows the direction of
gas flow
c Pressure regulator
d ½" female pipe threads
e Metal flex gas line
f Power cord (40"/1 m)
g 120 V receptacle
h Gas cut-off valve
i
Gas supply line connection fitting
j
Floor
Installation procedure en-us
¾"
(19)
11
Publicidad
