Beamz PS12W LED Spot 12W RGBW Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present,
and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear
damage from shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that
the product must be returned to the factory, it is important that the product be returned in the original factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising
condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains voltage
corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly
connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate electrical
ground to avoid the risk of electrocution or fire.
INSTALLATION
CAUTION:
Attention:

The installation of the product has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without
any harming deformation.

The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.

Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.

The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before
taking into operation for the first time and after changes before taking into operation another time.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled person once
a year.

The fixture should be installed in the position where persons cannot reach and where persons may walk by or be seated.
CAUTION:
Please consider the respective national norms during the installation!
The installation must only be carried out by an authorized employee
or dealers!
When installing the device, make sure there is no highly in inflammable
material (decoration articles, etc.) in between a distance of min 0.5
meter.
3