Briggs & Stratton NAX 700B Manual De Instrucciones página 38

To prevent accidents, all safety precautions and hazard avoidance must be followed. Any changes in the construction of the
device made by the user may affect the safety of use of the machine and release the manufacturer from liability for damage
or injuries.
RESIDUAL RISK
Despite the fact that the machine manufacturer bears responsibility for its construction eliminating danger, certain elements
of risk during operation are unavoidable. The residual risk arises from the erroneous behavior of the machine's operator. The
greatest danger occurs when performing the following prohibited activities:

use of the device by children,

use of the machine for other purposes than described in the Operation Manual,

when other people, especially children or animals are nearby,

use of the device by people not acquainted with the operation's manual,

using the device without proper, protecting operating clothing and footwear protecting foot,

using the device with damaged guards or the casing and without properly installed safety devices, e.g. shield
guards etc.
When observing the instructions in the operating manual, the residual hazards of using the machine may be eliminated.
There is a risk in case of failure to comply with the above recommendations.
USAGE
The brushcutter is used to mow the grass while taking care of home lawns. Using the included three-tooth knife, the
brushcutter can be used to cut thickets. The device is intended only for mowing lawns in accordance with the description and
safety rules contained in these instructions for use. Other applications may be dangerous to users and may cause damage to
the equipment.
The machine should not be used to:
- leveling molehills,
- cutting bushes,
- chopping branches.
ADDITIONAL INFORMATION FOR THE USER
Performing maintenance and adjustment work before or after the season can be a problem even for advanced users. The
NAX company would like to offer you a service consisting in preparing the machine for storage and / or work. The scope of
this service may include: replacement of the candle, cleaning of the working part, disassembly and inspection of the drive
belt, maintenance, oil change, replacement / cleaning of the air filter, lubrication of moving parts, sharpening and balancing of
the knife and other works depending on the condition of the device. This will ensure long-term and reliable operation and
safety of the device.
PREPARING FOR WORK
The brushcutter is delivered by the manufacturer in a cardboard packaging partially disassembled. After reading the
operating instructions and assembly drawings, assembling the brushcutter should not be too difficult. All necessary
components for assembly are included in the packaging.
38 EN