Publicidad
Idiomas disponibles
Idiomas disponibles
EN
INSTALLATION AND CONFIGURATION
For further details about the installation and configuration of the equipment, check the monitoring system "Installer's Guide".
DEVICE ATTACHMENT
Optionally, the device can be fixed by using the assembly holes (2).
RESET OF THE DEVICE
When the device is powered through the DC Jack by using the provided transformer, the POWER LED will light on,
indicating that the equipment is turned on. The equipment is turned off by disconnecting the power supply. To restart
the unit, press the button briefly. The POWER LED will remain on, while the other LEDs will turn off and on sequentially.
CAN BUS END OF LINE RESISTOR CONFIGURATION
Once the equipment is connected, follow the instructions below:
1. To activate the end of line resistor, switch the two switches E.O.L 1 and 2 in the ON position.
2. To deactivate the end of line resistor, switch the two switches E.O.L. 1 and 2 in the OFF position.
LED AND DIAGNOSTIC INDICATORS
LED
DESCRIPTION
POWER
Shows that equipment is connected.
STATUS
Shows the operating status of the equipment.
If it lights up, it means that the device is correctly
ONLINE
connected.
RX
The light flashes when the device is receiving data.
The light flashes when the device is transmitting
TX
data.
TECHNICAL FEATURES
POWER SUPPLY
VOLTAGE
2xCAN BUS, 4xUSB, 1xLAN RJ45,
CONNECTIONS
STATUS LEDS
PESO
4
838 851 R. 06/23
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
5 V DC
1xHDMI, 1xUSB 3.0
5
560 g
DIMENSIONS
153 mm (6.02 in)
44 mm
(1.73 in)
102 mm
(4.01)
Publicidad
