Publicidad
Idiomas disponibles
Idiomas disponibles
Tool Operation
REPlACING THE bIT HOlDER AND bIT
Pull the locking sleeve. The locking sleeve and adjusting sleeve come out of the gear casing as a set.
Pull the bit holder straight out. If it is difficult to pull by hand, use pliers. Push a new bit into the holder.
Use a new bit holder if necessary. Push the bit holder (with bit) into the hex hole of the spindle until the
ball lock snaps into the groove on the bit holder shank. Attach the locking sleeve (with adjusting sleeve)
to the gear case. Align the projection inside the adjusting sleeve with the groove of the gear case and push
the adjusting sleeve as far as it will go.
Adjusting Sleeve
Bit
Bit Holder
Locking Sleeve
SETTING DEPTH
The adjustable nose piece of the tool will automatically drive a screw to a preset depth. To adjust
your screwdriver so it will drive screws to the desired depth unlock the locking sleeve, turn the adjusting
sleeve until depth for bit holders or depth is obtained. Test drive a fastener in scrap materials to
determine if fastener is correctly seating. Further adjustment may be nec-essary to increase or decrease
the fastener depth.
Locking Sleeve
Adjusting Sleeve
DRIVING SCREWS
To engage the clutch to drive the screw, set the screw in the bit and align it in the desired position against
the work surface. Depress the trigger. With the motor running, push the tool forward to engage the clutch.
The clutch will disengage when the screw is driven to the selected depth.
7
Publicidad
