Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
FAUCET INSTALLATION
- Connect the sprayer head (1) to the sprayer head
connector (2) .
- Remove the gasket (3), metal washer (4), and retaining
nut (5) from the faucet .
- Install the faucet through the hole in the sink .
- From underneath, secure the faucet to the sink with the
gasket (3), metal washer (4), and retaining nut (5) .
- Tighten the retaining nut (5) by hand until it is snug .
Use a wrench to tighten it down . Gently tighten the two
screws on the retaining nut . Do not overtighten .
- Hand-tighten the hose (6) to the faucet outlet (7) .
Tighten the fittings using two wrenches. Hold the faucet
outlet (7) steady with a wrench while turning the hose
fitting with another wrench until it is snug.
NOTE: Failing to use two wrenches can damage the
faucet. Do not overtighten.
- Push the sprayer head (1) into the faucet neck . Install
the counterweight (8) a couple of inches from the
bottom of the hose on the side closest to the sprayer
head (1) . There should be no slack in the hose and it
should retract freely .
- Connect the water supply lines (not supplied) to the
faucet .
- This faucet is equipped with standard 1/2" NPS male
thread connectors that are compatible with standard
1/2" FIP water supply lines .
Sprayer Head
Connector (2)
Sprayer
Head (1)
Gasket (3)
Retaining Nut (5)
Counterweight (8)
Faucet outlet
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Faucet body
Metal Washer (4)
Screws
Faucet Outlet (7)
Hose (6)
Water Connectors
1/2" NPS thread
Hose
1/2" FIP water supply
line compatible
(not supplied)
CONGLOMKB .COM
Sink
Publicidad
