Publicidad
Fixing: Mount the inverter near the battery. There are four 3.5mm fixing holes, positioned 70mm
by 233mm.
FUSE REPLACEMENT: The unit relies for safety on an external fuse at source. There is a
backup safety fuse inside the unit which requires return to factory for replacement (as the unit will
have failed anyway).
SPECIFICATION:
Input Voltage, continuous:
Efficiency (Typical):
Input Power, No Load (typical):
230V AC Output Voltage:
115V AC Output Voltage:
Output Power, Continuous:
Output Power, Short term:
Output Power, Surge:
Ambient Temperature range:
Size and Weight:
SUPPORT:
Because of the specialist nature of these units, all technical questions should be
directed to SMET Ltd. on +44 (0)118 983 1222. We welcome queries to ensure your safety.
Ensure that the battery voltage is correct for the model. Do not reverse the polarity of the input
voltage. Use at least 4mm 2 wire to connect the converter to the battery. Fuse Battery at source.
Thin wire will cause fire hazard. Only operate the unit from a battery. Do not connect the unit to
any other power source. Do not use with capacitive loads greater than 2.0uF (230V), 4.0uF (115V).
Power factor correction capacitors must be removed from fluorescent lights. For inside use only.
Do not expose to moisture. Do not cover. The unit will run hot when under elevated load.
Disconnect the battery before changing the fuse. Do not operate the unit with the cover off. When
using tools outside, ground fault interrupter (RCD) protection must be used. Turn off when not in
use to avoid battery drain. This equipment is supplied on the basis of the user determining the
suitability of use. Not to be used for life support. Do not use in a moving vehicle without the
vehicle manufacturer's consent. Do not use for aviation or marine applications without our written
agreement. We reserve the right to change the specification without notice.
Information: +44 (0)118 983 1222
___________________________________________________________________________________________________________________________________________
Registered in England & Wales, Number 2218478. Registered .Office: Bell House, Ashford Hill Road, Ashford Hill, Berks. RG19 8BB. VAT No. (GB) 944 0645 24
±17% of nominal battery voltage.
90% (resistive load).
8W.
230V RMS 50Hz typical, 215V to 245V depending on
Load power. Maximum Load Capacitance 2.0uF.
115V RMS 50Hz typical,107.5V to 122.5V depending on
Load power. Maximum Load Capacitance 4.0uF.
700 Watts (resistive load).
800 Watts (resistive load), for five minutes.
1000 Watts (resistive load), for 500 mS.
-40C to +35C operating, -40C to +70C storage.
260mm by 103mm by 64mm. Weight: 1.55Kg.
SAFETY WARNING.
International Section Follows.
Web: http://www.custompsudesign.com.
Publicidad
