Beamz Rage 1000 SNOW Manual De Instrucciones página 5

CLEANING
After each use and before storing the device, use clean distilled water for cleaning the machine.
Procedure:
Turn off the power and pull out the plug from the socket.
1.
2. Remove snow fluid from the tank.
3. Add clean distilled water in the tank.
4. Plug the power lead and switch power on.
Run the machine until the tank is almost empty. Caution: Do not let the pump run dry!
5.
Caution: Do not refill the tank with snow fluid if storing the snow machine.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality snow fluid on water basis, specially designed for Beamz snow machines guarantees a
trouble-free use.
1 litre pack Snowfluid, Ref no. 160.578
5 litre pack Snowfluid, Ref no. 160.579
5