Axxess AXGM-10 Instrucciones De Instalación página 3

1) Turn the ignition on if not already, and then turn the radio on to verify that the
radio works. Check balance and fader controls for proper operation.
2) Push the Onstar button (if equipped) to verify Onstar is working. The radio
will shut off or mute, depending if the Brown wire on the 16-pin harness is
connected, and Onstar will be heard through the front speakers. Turn off Onstar
and the radio will turn back on.
Chime Volume Adjustment
Please refer to your owner's manual to adjust the chime level.
Audio Level Adjustment
(Potentiometer located on 16-pin side of
the interface)
1) Start your vehicle and turn on the
radio having audio playing.
2) Turn your aftermarket radio's volume
up ¾ of the way.
AXGM-10
Testing the AXGM-10
3) With a small screwdriver adjust the potentiometer clockwise to raise the audio
level and counterclockwise to lower the audio level.
4) Once at desired level your audio adjustment is complete.
OnStar Level Adjustment
To adjust the OnStar volume level find the Black/Yellow wire on the 16-pin
harness.
Push the blue OnStar button, while the voice is speaking tap the Black/Yellow wire
to ground.
There are 4 volume settings for OnStar; once the 4th setting is reached and the
Black/Yellow wire is tapped to ground it will automatically go back to the first
volume setting.
Once the volume is set it will stay at that volume until the Black/Yellow wire is
tapped to ground again. This can be set during installation and then left alone.
If user adjustment is desired, the customer may also tap volume up or down on the
steering wheel (if equipped) to adjust the OnStar level.
Potentiometer
3