YATO YT-17214 Manual De Instrucciones página 8

GB
TECHNICAL DATA
Index Lifting capacity [tons] Lifting range [mm] Weight [kg]
YT-17214 3,0 130 - 465 29,3
DESCRIPTION OF THE MACHINE
The hydraulic lift has been designed to be used for tasks implying lifting signifi cant weights. It must not be used as a permanent
support element. It is also unacceptable to use the lift to transport lifted loads. A correct, reliable and safe functioning of the device
depends on its adequate operation, so:
Before you commence work with the tool, read the operating manual thoroughly and keep it for future reference.
The supplier shall not be held responsible for any damage and injuries caused due to using the tool for purposes it has not been
designed for, failure to observe safety recommendations and the recommendations indicated within this manual. Using the device for
tasks which do not comply with the purpose it has been designed for shall also cancel the guarantee rights the user is entitled to.
SAFETY RECOMMENDATIONS
The lift is a hydraulic device working under signifi cant loads. During work it is required to observe basic safety principles.
Before you start work, read the operating manual and keep it for future reference.
Do not ever exceed the maximum load of the lift.
It is prohibited to use the device to lift people and animals.
The lift has been designed exclusively for the purpose of lifting, and must not be used for other purposes. It is required to use
additional safety devices (e.g. racks) to support the lifted object, before work under it may commence.
In case of lifting vehicles it is necessary to block or wedge the wheels and engage the safety brake.
Do not leave a lifted load unattended. Do net permit children and those who have not been trained in operation of the device to
enter the working area.
Do not wear loose clothes and jewellery. Gather long hair. Use personal protection means.
The lift must be placed on an even, fl at, hard and stable surface.
The lift must be placed upon the device to be lifted so that the load is supported in the middle section of the saddle.
It is absolutely prohibited to adjust the safety valve.
Keep the device far from sources of heat and fl ames, since they might damage the device or impair its functioning.
Before you proceed to lifting any load whatsoever, make sure that once the load has been lifted, the lift will not shift.
Before you proceed to lifting any load whatsoever, male sure the lift is not damaged in any way. If the lift requires repair, have it
repaired by an authorised workshop.
Be prudent and do not work when you are tired or under infl uence of medicines.
Do not modify any elements of the lift, which may have impact on the compliance of the lift with the standard indicated in the
declaration of compliance.
Have the device repaired exclusively in authorised service points, using solely original spare parts, so as to ensure the required
level of safety during work.
The condition of the marking must be checked and that the marking remains as it was at the beginning.
The lifetime of the lift has been determined for 4 years from the date of its fi rst use. After this period, the lift should be inspected
at the manufacturer's authorized service center for further safety of use.
ASSEMBLY AND OPERATION OF THE LIFT
The lift is delivered as an assembled system and does not require assembly or adjustments.
Before work it is required to realise approximately six full pumping cycles with the release valve open, so as to ensure appropriate
distribution of the hydraulic oil.
Loosen the clamping screw, then insert the lifting arm into the socket and tighten the clamping screw (II). Make sure the arm will
not slip out of its seat. Attach the extension to the arm.
Lifting
Before lifting may commence, make sure that the operator of the lift has the lift itself and the lifted load within the range of sight
during all realised movements.
Using the end of the arm of the lift, close the release valve turning it home clockwise. (III)
Place the lift under the load to be lifted in the place designed for a lift (e.g. in case of vehicles), so that the load is supported in the
central section of the saddle of the lift. (IV)
O R I G I N A L I N S T R U C T I O N S
8