Omni cubed SLIM SLAB TABLE HD Manual Del Usuario página 5

1. Lay out the rails and leg brackets
upside down as pictured.
2. Align the leg brackets and use the
include 3/16" hex key to fasten the
captured screws to the rails.
3. Loosen the leg bracket screws, slide
the legs onto T-nuts and tighten the
screws.
4. Turn the table upright.
5. Store the hex key in the leg bracket.
6. Use the leveling feet to level the table.
7. Install the material support pucks
where needed.
8. Remove the material stop posts from
their stored position and install where
needed.
9. Optionally, use the table connectors to
connect two tables a pictured.
INSTRUCTIONS
3
en
omnicubed.com