BOMANN EKI 5026 CB Instrucciones De Servicio página 44

NOTE:
You must now press the SELECT button within
60 seconds, or the hotplate will switch back to the operat-
ing mode of standby.
Selecting performance, shut-off time or temperature as the
function.
Press the SELECT button to select the control by power, shut-
off time or temperature. The indicator lights POWER, TEMP.
and TIME will show the selection.
Selecting the power or temperature of the hotplate
• Use the UP or DOWN buttons to select one of 10 power
settings between 200 and 2000 W, or one of 10 tempera-
ture settings between 60°C und 240°C.
• The MAX or MIN buttons can be used to directly select
the highest or the lowest power setting and temperature
setting. The maximum or minimum power setting will
appear on the display.
NOTE:
• The hotplate will always start at the sixth power set-
ting with a temperature of 180°C or with 1200 W.
• The display shows the selected setting. The
respective pilot lamp above the SELECT button will
also light up.
• Please observe that the cooking behavior in the pots
differs. It depends on the nature and the quality of the
cooking vessels.
Enter Off Time
1. Turn the appliance on and select any range or temperature.
2. Press the SELECT button to select the control after the
shut-off time. The display will show "0". The indicator light
TIME above the SELECT button will flash.
3. Set a turn-off time between 5 and 180 minutes by using the
UP or the DOWN button.
NOTE:
• Press the UP or DOWN buttons to set the time in
increments of 5 minutes. The display will show the
desired setting.
• Once you have set a time, the display will remain
for a few seconds. The remaining time and the
function that you have chosen beforehand are then
shown alternately.
• You may change the previous turn-off time at any
time. The other settings (POWER and TEMP.) will
remain.
• After the set time has elapsed, the cooking time will
automatically be turned off and a beep will sound. The
appliance is in standby mode again.
• In order to cancel the shut-off time beforehand, set
the time to "0". You may also turn the appliance off
directly with the ON/OFF button.
44
Child safety
To safeguard against unwanted use, the appliance is equipped
with a disable function.
• In order to activate the child lock, press the UP and DOWN
buttons simultaneously. The display will show "L".
• Press the UP and DOWN buttons again at the same time
to cancel the disable function.
NOTE:
When the child lock is active, all the buttons except for
ON/OFF are locked. The appliance can only be operated
again after unlocking it.
Automatic shut-off
The hot plate turns off automatically after 120 minutes, if no
input was given over the operator control panel during this time.
This switching serves as security for you.
Switching off
1. Press the ON/OFF button.
NOTE:
• The hot plate is reset from its operational state to
standby mode. The fan may continue to run for a
period of time.
• The indicator lights will go out.
2. Pull the plug.
3. Let the device cool down, before you put it away.
Pan recognition
The device has a pot recognition function. It gives several
warnings to indicate that the cookware has been removed. The
message "E0" appears on the display. For safety reasons, the
appliance will switch to standby mode after about 30 seconds.
The fan may continue running.
In this context, please pay attention to the following:
WARNING:
After use, the hot plate is to be switched off by means of its
regulation and control devices ON/OFF button and not just by
pan recognition.
WARNING: Hazard of burns!
Because of the heat radiated during cooking, dangerously
high temperatures may occur at the cooking zone after the
cooking cycle.