Courtyard Creations KTS751G Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE!
PARTS LIST
PART
MATERIAL CODE
NO.
1 KTS751G-CS11-1
2 KTS751G-CS01-2
3 KTS751G-CS01-3
4 17C40A0705001YX
5 17C02A0755131YX
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
Step 1:
Place the right arm (#3) onto a non-abrasive surface,
such as a carpet. Fasten the seat assembly (#1) to
arms (#2 and #3) by using bolts (#4). Keep the bolts
loose. See Figure 1.
Note:
The labels marked "L" and "R" on arms (#2 and #3)
should coincide with Figure 1 to ensure proper
assembly.
! Use the correct bolts as indicated. Do not tighten any of the bolts until the chair is completely assembled.
! Do not discard of any of the packaging until you have checked that you have all of the parts and fittings
required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
!
Children should always be under direct adult supervision while using this product.
!
Retain these assembly instructions for future reference.
!
Quote the following FQC No. when contacting the service center.
V-3
All manuals and user guides at all-guides.com
INTENDED FOR RESIDENTIAL USE ONLY.
KTS751G
PART Q'TY
SEAT ASSEMBLY
LEFT ARM
RIGHT ARM
BOLT M6*15
BOLT M6*14
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
STOP DO NOT RETURN TO THE STORE!
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
1 6 17KAA0101----Y4
1 7 17KAA0201----Y4
1 8 17KAC3101----Y3
6 9 61K751GX00001BA
2 10
61K751GY00001BA
FIGURE 1
2
4
PART
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 6MM
HEX. KEY WRENCH 10MM
BACK CUSHION
SEAT CUSHION
L
1
R
3
15
#4 BOLT M6*15
COURTYARD CREATIONS INC.
Q'TY
1
1
1
1
1