Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL SETUP
1. When testing is complete, set the DUALBRITE switch
to the desired amount of time after dusk the lights should
remain on at a reduced light level [Off, 4 Hrs., Dusk-to-
Dawn (D2D)]. See Optional DualBrite® Control section
for more information.
2. The amount of time the lights stay on at full bright after
ALL motion has stopped in front of ALL linked lights
is preset to 5 minutes.
LINK TECHNOLOGY
Link technology allows multiple lights to be connected
together wirelessly. When one light senses motion it will
turn on full bright and send out a wireless signal. All lights
within range and on the same channel will also turn on full
bright. Each time a light receives a signal, it will then repeat
the signal so other lights not in range of the first light will
also turn on full bright. Linked lights can be grouped into
one of three possible channels (A, B, or C) to create linked
zones of lighting. Note: Linked lights turn off independently
of each other and may not turn off at exactly the same time.
Illustration example: Light #1 senses motion and sends a
signal. Light #2 is out of range of light #1 and does not
receive the signal. Light #3 is in range of light #1 and receives
the activation signal. Light #3 is activated and repeats the
signal. Light #2 is in range of light #3 and is activated. Note:
All the lights will send out a signal when activated, even if
the light's DualBrite switch is set to OFF. If the light is in
manual mode, it will repeat any signal it receives but will
not initiate a signal.
2
3
1
OPERATING MODES
Mode:
On-Time
Test
5 Seconds
Auto
5 Minutes
Off, 4 Hours, Dusk-to-
Accent
Dawn
Manual
6 Hours or Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The amount of time the lights stay on at full bright
after ALL motion has stopped in front of ALL linked lights
is preset to 5 minutes.
• Optional DualBrite® Control – DualBrite mode is
a selectable feature that turns the light on at dusk in a
reduced light level. The light will stay on at the reduced
light level for the amount of time selected [Off, 4 hr.,
dusk-to-dawn (D2D)]. When motion is detected, the light
will increase to full bright. The light will stay on at the full
bright level for 5 minutes after ALL motion has stopped
in front of ALL linked lights. The light will then return
to the reduced light level. Once the DualBrite timer runs
out, the light will turn ON only when motion is detected
by any of the linked lights. Selecting OFF disables the
DualBrite feature, however the motion sensing and Link
features will continue to work.
For linked lights, the first light to sense darkness will
turn on all other linked lights on the same channel if the
DualBrite timer has been turned ON on each linked light.
The lights will turn OFF independently of each other and
may not turn OFF at exactly the same time.
6
Works: Day Night
x
x
x
x
x
/
minutes for
1
2
209819-01
Publicidad
