Publicidad
Idiomas disponibles
Idiomas disponibles
Risk of burns:
There is a potential risk of burns as the Printer head (extruder) can reach up to 270°C. The use of common sense should be sufficient to
prevent burns, but in some environments it is highly recommended to provide additional protection. (see § Mechanical safety and protection)
!
Always let the 3D printer cool down for 60 min. before maintenance or modification.
Health:
This printer is designed for use with PLA and ABS filament (MSDS for the Velleman filament is available).
PLA: is a safe and non-toxic material, there are no known health safety risks when used in 3D printers.
ABS: when printing with ABS there is a distinctive 'burned plastic' smell. This is quite normal but it may also cause headaches, res-
piratory- and eye irritation with sensitive people (although it is not toxic)
Only use the printer in a well-ventilated area, if printing with ABS it is advisable to add a fume hood (with active carbon
!
filtering for ductless extraction). Fume extraction is mandatory for use in offices, classrooms and alike.
Never burn printer filament, toxic gasses and vapors will be generated if exposed to fire.
General safety information:
The 3D printer is not intended for use by persons (including children) with reduced physical, or mental capabilities, or lack of experience
The 3D printer is not intended for use by persons (including children) with reduced physical, or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
for their safety
for their safety
Children should be supervised to ensure that they do not play with the appliance.
Children should be supervised to ensure that they do not play with the appliance.
The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide.
The information in this document was obtained from sources which we believe are reliable.
However, the information is provided without any warranty, express or implied, regarding its correctness.
The conditions or methods used for assembling, handing, storage, use or disposal of the device are beyond our control and may be
beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, injuries,
damage, or expense arising out of or in any way connected with the assembly, handling, storage, use or disposal of the product.
Getting started
Illustrated assembly instructions:
www.vertex3dprinter.eu/manual
3D-printer info, specifications,...
www.vertex3dprinter.eu
- 3 -
Support
(Downloads, Product support, Community)
www.vertex3dprinter.eu/support
Publicidad
