Publicidad
Idiomas disponibles
Idiomas disponibles
Before use, On/off knob must be on the
Then, plug in your appliance. Rotate the on/off knob clockwise to switch on the appliance and select the
desired operating mode:
Fan setting: cool air mode
I : low power heating mode
II : high power heating mode
The working light indicator will be turn of when the device will start heating the environment. If the
selected temperature is bellow the ambient temperature, the device will not start to heat and the working
light will be turned on.
Then, turn the thermostat knob.
To find out the ideal thermostat setting, first set the dial to the maximum setting (+). As soon as the
temperature is conformable, slowly turn the thermostat down to the minimum setting (-), until the heater
turns off.
NOTE: To avoid power circuit overload situation, it is recommended that no other appliances are
operating at the same time from the power outlet it is plugged into.
Overheat protection
The heater is fitted with a safety device which will switch off the heater in case of accidental overheating
(example: obstruction of air intake and outlet grilles, motor turning slowly or not at all) . To reset,
disconnect the plug from the power for approximately 10 minutes, remove the cause of overheating then
plug the appliance in again.
Cleaning and maintenance
Before cleaning always turn off the appliance, unplug it and let the appliance cool down.
To remove dust from the appliance use dry cloth or vacuum cleaner.
Table
Model number:
Item
Heat output
Nominal heat out-put
Minimum heat output (indicative)
Maximum continuous heat output
Auxiliary electricity consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat input, for electric storage local space heaters only (single select)
manual heat charge control, with integrated thermostat
manual heat charge control with room and/or outdoor
temperature feedback
Model identifier for electric local space heaters
DOM476
position and the thermostat knob at the minimum setting.
Symbol
Value
P
1.8-2.0
nom
P
0.9
min
P
2.0
max,c
el
N/A
max
el
N/A
min
el
0
SB
www.livoo.fr
Unit
kW
kW
kW
kW
kW
kW
Yes
No
Yes
No
Publicidad
